• Pressure wash entire surface with minimum 2800 psi.

• Carefully wipe or wash off all sawdust residue from logs and surrounding surfaces; eg, window frames, gutters, downspouts, etc.

• Prior to application, pressure wash entire surface to remove any dirt or residue.

APPLICATION

Before using always stir stain thoroughly. Apply by either:

• Pre-dipping wood prior to construction will provide optimum protection.

• Spraying (either low-pressure or airless) by flooding the surface to maximum absorption and back roller or wipe with damp towel immediately. 

• To obtain maximum protection a minimum of 3 applications is recommended.

• Unless a varnished appearance is desired, do not apply in direct sunlight or in the heat of the day.

• Do not apply if rain is likely to occur soon after application.

CLEAN UP

Clean hands and tools with soap and water

MAINTENANCE

To retain a quality appearance, the surface should be cleaned with a pressure washer. Apply with additional LOG BOSS™ as necessary. A high degree of protection will remain regardless of appearance, due to previous applications of LOG BOSS™ that have bonded with the cellular structure of the wood.

COVERAGE:

Weather-Bos™ products will have an average coverage between 50 to 100 sq. ft. (4.7-9.29 sq. ms.) per U.S. gal. on each application depending upon surface and conditions.

If swallowed, drink milk or warm water, induce vomiting and call a physician.

This product complies with all California and Federal V.O.C. limitations.